We diagnose the actual water source before we quote anything — no guessing, no upsell, just a plan sized to your basement.

Basement waterproofing mistakes usually come down to one thing: fixing the symptom instead of the source. A contractor who paints over a wet wall without checking cove joint condition or exterior grading is setting you up for the same call again in a year or two.
We're bonded and insured for both residential and light commercial basement work across Maplewood, MN.
Most inspection requests get a same-day or next-day appointment, not a two-week wait.
You get one written number before drilling starts, covering drain tile, sump basin, and discharge line.
We use pin-type moisture meters and a flashlight-and-crowbar inspection to trace water back to its real entry point.

We scope every Basement Waterproofing job in person before quoting it, since two properties with the same symptom rarely need the same fix.
The core fix for most Maplewood, MN basements: a perimeter drain cut into the slab edge, tied to a sump basin, that intercepts water before it reaches the floor.
Every drain tile system needs a properly sized sump pump — we calculate basin size and pump horsepower from your square footage and local water table depth.
The cove joint where the floor meets the foundation wall is one of the most common Maplewood, MN leak points, and we seal it as part of every interior system.
We install membrane on masonry walls before any insulation or framing goes up, so moisture never gets a chance to reach finished materials.
Poor window well drainage is one of the most overlooked Maplewood, MN basement leak sources, and it's often the cheapest fix on the list.

A quick phone conversation lets us bring the right equipment on the first visit instead of a second trip.
A technician walks the basement with a moisture meter, checking walls, floor, and cove joints to trace the water back to its actual source.
You'll see drain tile footage, sump specs, and labor broken out separately, not one vague lump-sum number.
Most residential basement jobs finish in one to three days, and we test the sump pump under load before we leave.

"Our finished basement started smelling musty and we finally found a wet spot behind the drywall. They cut open the cove joint, ran drain tile, and it's been dry for over a year."
— Maplewood Homeowner
"Sump basin was undersized from the last owner's DIY job. They resized it and we haven't had a drop since."
— Maplewood Customer
"They walked us through exactly why the water was coming in before quoting anything, which no one else had bothered to do."
— Maplewood Homeowner
"Basement had been damp for years. Drain tile and a new sump system fixed it in three days."
— Maplewood Customer
Every Maplewood, MN quote is itemized in writing so you can see exactly what drives the total.
We keep the cut as narrow as possible and clean up debris before leaving the site.
Larger basements or those needing extensive crack repair can take a bit longer — we'll give you a realistic timeline in the written quote.
Not always — an isolated, non-leaking crack can sometimes be handled with injection alone.
Coverage depends on your policy and the cause of the water intrusion — we can document conditions for a claim, but approval is up to your insurer.
Warranty terms are often transferable if you sell the property later.
We install interior drain tile and sump systems throughout Maplewood and the surrounding Maplewood, MN service area, including the zip codes listed below.



Zip codes we serve in Maplewood, MN: 55117 55119 55109
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.